Marine Boy
Super Freak
Added the rear interior panels and cross bracing. Next step is the roll cage.
Exterior door handles made. These will be functional.
Exterior door handles made. These will be functional.
Last edited:
1/6 Scale Mad Max V8 Interceptor (scratchbuild)
- Thread starter Marine Boy
- Start date
Help Support Collector Freaks Forum:
Marine Boy
Super Freak
Roll cage made and fitted.
Did a bit more work to the rear wheels.
Started making the frame for the jump seat.
I've used square brass rod inside for strength.
Did a bit more work to the rear wheels.
Started making the frame for the jump seat.
I've used square brass rod inside for strength.
Marine Boy
Super Freak
Finished making the seat.
Making the fuel tank. I started by making the basic shape, then adding strips to create the ridges.
I will make it detachable to hide the battery bank.
Making the fuel tank. I started by making the basic shape, then adding strips to create the ridges.
I will make it detachable to hide the battery bank.
Marine Boy
Super Freak
Making the iconic hood scoop. I started with the base and the lower part of the scoop.
The top part is shaped them glued into place.
After much tidying up, it's fitted to the block. There are still a few pipes to add to the base.
The top part is shaped them glued into place.
After much tidying up, it's fitted to the block. There are still a few pipes to add to the base.
Marine Boy
Super Freak
Making the bonnet hinges.
Adding detail to the underside of the hood.
Hinges glued into place. The tape is to maintain a consistent panel gap.
Adding detail to the underside of the hood.
Hinges glued into place. The tape is to maintain a consistent panel gap.
Marine Boy
Super Freak
I made a mounting plate for the motor, to drive the supercharger belt.
Motor attached. I will build the gearbox casing around the motor to hide it.
Kick it in the guts, Barry!
Motor attached. I will build the gearbox casing around the motor to hide it.
Kick it in the guts, Barry!
Marine Boy
Super Freak
Making the inner bumper. I reinforced the joints with brass rod.
The finished bumper is screwed into place. At first, i wasn't going to bother making this part, as i much prefer how it looks undamaged. Then i realised, much of the inner structure is visible once the hood is opened.
The nose is removable for the sake of completeness.
The finished bumper is screwed into place. At first, i wasn't going to bother making this part, as i much prefer how it looks undamaged. Then i realised, much of the inner structure is visible once the hood is opened.
The nose is removable for the sake of completeness.
Similar threads
Latest posts
-
Hot Toys Obi-Wan Kenobi (The Clone Wars)
- Latest: The Glorious League Freak
-
-
-
Hot Toys 1/6 Wrecker The Bad Batch figure
- Latest: The Glorious League Freak
